Known issues

  • TX65 product models

    Limitation

    Detail

    Reference

    VLANs on ETH2–ETH5​

    Not supported. The 2.5 GbE WAN port has full VLAN functionality — route the tagged traffic there.​

    DAL-13777​

    COPT-48​

    UDR (dead reckoning)​

    Not native. Supported only via an external USB UDR module, the same as TX64 and TX54.​

    -----

    SIM PIN / PUK​

    Not implemented on the modem controller.​

    DAL-12463​

    Digi RealPort​

    Not supported on this platform.​

    -----

    Cellular as Time Source​

    Not implemented yet​

    DAL-13948​

    Limited space for scripts​

    8MB partition in /etc/config/ limits available space for python scripts/modules​

    DAL-13966​

    WPA PSK support

    Not working in Wi-Fi client mode. WPA2 and WPA3 PSK support is working correctly.

    -----

  • TX54 product models

    The Serial status and statistics for the TX54 are incorrect on the Web UI and CLI (DAL-5763].

  • Bridging traffic from devices connected on an Ethernet port or Wi-Fi AP

    Due to the changes in the firewall, it is currently not possible to bridge traffic from devices connected on an Ethernet port or Wi-Fi AP in a bridged interface to a remote IP device via a gateway connected to an Ethernet port in the same bridged interface [DAL-9799].

  • IPsec using Default Router as the Local Endpoint

    There is an issue with IPsec where the tunnel will not come up when the default route is used as the Local Endpoint and the tunnel is not acting as the initiator. Specifying the interface type for the local endpoint should resolve the issue. [DAL-11361].

  • SSH / SCP login slow when FIPS mode is enabled

    Logging into SSH or SCP when FIPS mode is enabled can take more than 20 seconds. [DAL-12606].