26.10.126.22 - November 2026, Feature

PDF link

Release category: Mandatory

These release notes document the changes since DAL release 26.7.90.15.

Enhancements

  1. The following support has been added to the TX65, EX60 and EX61 platforms (DAL-14056, DAL-14051, DAL-13948, DAL-12463, DAL-13185)

    • VLAN support

    • VRRP support

    • Cellular as a time source

    • Cellular SIM PIN/PUK support

    • USB-to-Serial adapters

  1. The Ethernet ports on the EX61 platforms have been swapped so that WAN/ETH1 is on the left and ETH2 is on the right. This is to have the Ethernet PoE support on the ETH2 (LAN) port. (DAL-14398)

  2. The time zone database has been updated to reflect recent changes to Canadian daylight saving time. (DAL-14373)

  3. Post Quantum Encryption support has been added to the Web UI and IPsec support. (DAL-13506)

    Note PQC encryption cannot be used on IPsec tunnels when FIPS mode is enabled.

  4. The default IPsec tunnel configuration has been updated to (DAL-9930)

    • IKEv2

    • Phase 1 - AES256, SHA256, Diffie Hellman ECP521, ML-KEM-768

    • Phase 2 - AES256, SHA256, Diffie Hellman ECP521, ML-KEM-768

      Note Any existing IPsec tunnel configuration will not change with a firmware update.

  5. The eSIM support has been updated so that the bootstrap profile can be disabled. (DAL-13766)

  6. The system find-me command has been update to support color, duration, mode and flash speed options over the LEDs on the device. (DAL-14279)

  7. The Primary Responder mode is no longer automatically enabled on a IX25 platform when a FirstNet SIM is detected. (DAL-14229)

  8. There have been various updates to the Digi Remote Manager support (DAL-14164, DAL-14222, DAL-14118, DAL-13974, DAL-13487, DAL-12820)

    • The uptime is now reported for all interfaces in the Query State response.

    • The Enhanced Location Services now includes Ethernet details in the Query State response.

    • The device will now respond to a Digi Remote Manager set_setting request before disconnecting.

    • Digi Remote Manager will now report the connection type as Wi-Fi instead of Ethernet when the device is using an Wi-Fi interface to connect to Digi Remote Manager.

    • When running a Speedtest in Digi Remote Manager on a device, the device will only report interfaces that are up.

    • The device will now close port 977 before disconnecting from Digi Remote Manager.

  9. A device will now detect if a Verizon APN push has occurred in establish connections over the Verizon network quicker. (DAL-13585)

  10. The modem registration timeout setting has been changed to a non-debug parameter. (DAL-13181)

  11. The Wi-Fi driver in the TX40 updated to the latest version. (DAL-12336)

  12. The NTP service will now respond with the on-board system time within one minute of the device booting. (DAL-12695)

Bug fixes

  1. An issue where eSIM profile failover would not work if the SIM slot setting was not set to “any” has been resolved. (DAL-14471 and DAL-14554)

  2. The Ethernet EEE support has been disabled on the TX54 and EX15 platforms. This had led to some Ethernet instability issues seen on the TX54 platforms. (DAL-14521)

  3. An issue where the UTC time reported via GNSS could off by up to 40 seconds has been resolved. (DAL-14473)

  4. An issue where an incorrect CID could be used for T-Mobile connections with the Telit LE910C4-WWXD modem has been resolved. (DAL-13129)

  5. An issue with the Query State failing when the modem is initializing or resetting has been resolved. (DAL-14525)

  6. An issue with the show esim command leaking temporary or stale data has been resolved.

  7. An issue with the SIM PIN/PUK support on the TX65, EX60 and EX61 where we were not waiting for the SIM to be ready has been resolved. (DAL-13380)

  8. An issue where the Digi Remote Manager client could crash has been resolved. (DAL-14472)

  9. A broken link to documentation on the Web UI File System for the IX25 and TX65 has been resolved. (DAL-14560)

  10. The following issues with the TX65, EX60 and EX61 platforms has been resolved. (DAL-14447, DAL-14314, DAL-14165, DAL-14009, DAL-13956, DAL-14350, DAL-14418, DAL-13926, and DAL-13793)

    • DHCP packets being leaked on other Ethernet ports in a LAN bridge group.

    • A cellular connection would use the default context ID instead of the carrier specific context ID.

    • The internal eSIM support has been removed from the WWAN2 interface on the TX65 Dual Cellular variant.

    • The CLI reboot command never returned a prompt before dropping the SSH connection.

    • A cellular connection could be established before a scheduled SIM switch has occurred.

    • A device configured with the SIM failover alternative reboot action would reboot continuously when it could never connect.

    • Wi-Fi access points did not come up after boot up.

    • The TX65 Dual Wi-Fi variant displayed a WWAN2 interface.

    • Devices where storing analyzer captures and scripts which resulted in a memory shortage.

  11. Issues with the EX61 Power, Ethernet, and Power LEDs have been resolved. (DAL-14255 and DAL-14251)

  12. A number of eSIM issues have been resolved. (DAL-14372, DAL-13960, DAL-14371, DAL-14159, DAL-13663, DAL-14243, DAL-14337, DAL-14301, and DAL-13922)

  13. A number of GNSS issues have been resolved. (DAL-14438, DAL-14454, and DAL-14455)

    • An incorrect baud rate being used to communicate with the GNSS module.

    • The location support reporting no fix for an hour after configuration changes.

    • The RMC sentences missing the mode indicator field

  14. An issue where a template scan failed to remediate the settings for the multicast service has been resolved. (DAL-14420)

  15. An issue where the Web UI serial signalling menu offering RS-422 on products that do not support it has been resolved. (DAL-14313)

  16. An issue where the IPsec service could deadlock, causing the show ipsec command to hang, has been resolved. (DAL-14295)

  17. The following issuses with the EX50 Wi-Fi support have been resolved. (DAL-11813, DAL-11555, and DAL-14262)

    • A Wi-Fi client configured for WPA2-PSK/WPA3-SAE could not connect to an access point configured for WPA2-PSK.

    • Wi-Fi scan not working.

    • Wi-Fi access points not staying up.

  18. An issue where DMVPN tunnels were not initiated after an IPsec service outage longer than 45 seconds has been resolved. (DAL-14250)

  19. An issue where a firmware update was denied by the device when a Digi Remote Manager scan interrupted an update in progress has been resolved. (DAL-14202)

  20. An issue where SIM failover never triggered when the SIM slot was absent has been resolved. (DAL-14169)

  21. An issue with the firewall configuration in the Web UI where the ICMP configuration options appeared starting with the sixth firewall filter has been resolved. (DAL-14163)

  22. An issue on the EX50 where it could drop UDP traffic has been resolved. (DAL-14087)

  23. An issue where some TELUS SIMs were incorrectly detected as eSIMs has been resolved. (DAL-14076)

  24. An issue where USB-to-Serial adapters were not supported has been resolved. (DAL-13972)

  25. An issue where the query state response failed with an invalid MAC address error for the ARP table has been resolved. (DAL-13934)

  26. An issue where the CLI did not handle product variants has been resolved. (DAL-13930)

  27. An issue where SIM failover never triggered when the active SIM slot was empty has been resolved. (DAL-13919)

  28. An issue where two QoS bindings on the same interface overwrote each other has been resolved. (DAL-13863)

  29. An issue where QoS rule matching did not work correctly for values, port ranges, protocol selection, IPv6 and latency units has been resolved. (DAL-13835)

  30. An issue where a modem reset set the APN to blank, which prolongs the Verizon connection time, has been resolved. (DAL-13861)

  31. The device will now connect using the last known good APN instead of a blank APN. (DAL-13847)

  32. An issue with the IX40 were the Ethernet ports could lock up has been resolved. (DAL-13736)

  33. An issue where VRRP failover and failback could took many minutes has been resolved. (DAL-13718)

  34. An issue where a device did not reboot when required by the SureLink and advanced watchdog settings has been resolved. (DAL-13702)

  35. An issue where a Query State report was missed after a daemon restart caused by an NTP sync has been resolved. (DAL-13689)

  36. An issue where a Query State error occurred when the ARP cache exceeded 100 entries has been resolved. (DAL-13614)

  37. An issue where Query State error occurred with incompete IPsec tunnel information has been resolved. (DAL-13592)

  38. An issue where a custom DDNS password being configured using Digi Remote Manager templates as plain text has been resolved has been resolved. (DAL-13548)

  39. An issue where the Web UI Apply button did not appear after using Set to default has been resolved. (DAL-13296)

  40. An issue where the Quectel EG25-G modem reports a temperature of 0C has been resolved. (DAL-13277)

  41. Misleading "invalid key 'device" log messages for the IPsec configuration has been resolved. (DAL-13269)

  42. The behavior of the Web UI Apply button has been corrected. (DAL-13261)

  43. An issue where spikes appeared in the cellular RX/TX byte values being reported in the Query State data has been resolved. (DAL-13244)

  44. An issue where the watchdog did not detect that the modem had disappeared from the USB interface has been resolved. (DAL-13144)

  45. An issue where PLMN 26202 was incorrectly mapped to Telekom Deutschland instead of Vodafone has been resolved. (DAL-12978)

  46. An issue where the LAN interface could fail after the hotspot configuration was disabled has been resolved. (DAL-12608)

  47. Superfluous log messages relating to IPv6 VLAN support has been removed. (DAL-12269)

  48. The Bondix WAN Bonding client has been updated to 1.26.08.1. (DAL-10273)

  49. An issue where the TX65 and IX25 firmware updates from the CLI and Web UI did not work has been resolved. (DAL-14209)

Security fixes

  1. A security issue with Linux TCP has been patched. CVE-2026-98432 9.8 Critical

  2. The glib package has been updated to 2.90.1

  3. The following package and certificate support has been updated to remove the compromised eMudhra certificates.

    • The CA certificate list stored on the device

    • The Python Certifi module has been updated to 26.10.23

    • The Python PIP module has been updated to 26.2.2

  4. The Linux kernel has been updated to 6.18.49

  5. The OpenSSL package has been updated to 3.6.5

  6. The OpenSSH package has been updated to 10.5

  7. The Python support has been updated to 3.13.16

  8. The Expat package has been updated to 2.9.0

  9. The DNSMasq package has been updated to 2.93

  10. The libpcap library has been updated to 1.10.7

  11. The rsync package has been updated to 3.5.0

  12. The unbound library has been updated to 1.26.1

  13. The Ookla package has been updated to 3.9

  14. The socat package has been updated to 1.8.1.3

  15. The libusb library has been updated to 1.0.30

  16. The libldns library hs been updated to 1.9.2

  17. The sqlite package has been updated to 3.51.1

  18. The Net-SNMP package has been updated to 5.9.5.2

  19. The OpenVPN package has been updated to 2.7.7

  20. The Busybox package has been updated to v1.38

  21. The bondixclient package for WAN Bonding has been update to versoin 1.26.08.1

  22. A security issue when using LDAP with the Web UI has been resolved.

  23. A security issue with IPsec has been resolved.

  24. A security issue with Web UI authentication has been resolved.

  25. A security issue with how dnsmasq configuration was being manged has been resolved.

  26. A security issue with how Web UI manages cross-site scripting has been resolved.